Tune and Adjust
Quoted after a first look
- Full door and opener inspection
- Track alignment and roller check
- Lubrication and balance test
- Safety reverse and sensor test

Garage Door Repairs in Bellingham, Massachusetts start with a real diagnosis, not a guess. We test the torsion springs, cables, rollers and opener, then tell you what failed and what it costs before we touch a tool.

We test the springs, cables, rollers and opener under load before quoting anything. You see the failed part and get a written estimate. Then we repair, cycle the door ten times, and check the safety reverse.
The broken spring or frayed cable, shown to you
Springs, cables and rollers for one-visit repairs
Balance and safety reverse checked before we leave
One call covers the whole door: springs, cables, rollers, tracks, panels and the opener.
General Garage Door Repairs in Bellingham, Massachusetts cover noisy operation, uneven door travel, worn nylon rollers and steel rollers, loose hinges and bent tracks.
A broken torsion spring or extension spring makes a door nearly impossible to lift by hand.
Opener motor failure, a remote not working, sensor misalignment and stripped gears are the calls we get most.
A snapped cable drops one corner of the door and can send it off the track.
An off-track door usually means a bent track, a failed roller, or a cable that let go.
We are a local shop, not a call center.
Call before noon and we can usually be at your door the same afternoon.

Before anything is replaced, we show you the broken spring, the frayed cable or the cracked roller. You see the wear with your own eyes.

We set the opener to UL 325 safety reverse, check the photo-eye sensors, and follow ANSI/DASMA 102 installation practice on every door we touch.

Typical 2026 pricing in the Bellingham area is below. Every job gets a written estimate before we start, and the number on the estimate is the number you pay.
Quoted after a first look
Quoted after a first look
Quoted after a first look
The process is the same whether you have a snapped cable at 6 a.m. or a noisy door you have been ignoring for a month.
Step 1
Tell us what the door is doing: will not open, will not close, hangs crooked, or makes a bang.

Step 2
We test the springs, cables, rollers, tracks and opener under load. You get a clear explanation of what failed and why, plus a written estimate before any work begins.

Step 3
We complete the repair with the right parts, then cycle the door at least ten times.

Step 4
You operate the door yourself while we watch.

Most garage door failures announce themselves before the door stops working completely.
The spring snapped on a Sunday night and the door would not budge. They came out Monday morning, showed me the broken coil, and had both springs replaced before lunch. The door is quieter than it has been in years. Fair price and no upsell on a new door.
Marisol R.Homeowner, Downtown Bellingham
My opener would hum and nothing moved. The technician tested the motor, found stripped gears, and had the parts on the truck. He also realigned the sensors while he was up there. Took about an hour and a half and the door has been fine since.
Devon A.Homeowner, Fairhaven
One corner of the door dropped and I could see the cable was frayed. They replaced both cables, reset the drums and straightened a bent track. Explained why running it that way would have bent the panels. Honest work and they cleaned up after themselves.
Priya N.Homeowner, Downtown Bellingham
Called about a noisy door and expected to be told I needed a new one. Instead they lubricated the rollers, adjusted the track and tightened the hinges. Cost me the minimum and the noise is gone. I appreciated that they did not try to sell me anything.
Tomás G.Homeowner, Fairhaven
The door froze shut in January and I did not want to force it. They came out, freed it without damage, replaced the weather seal and adjusted the down limit. Also gave me a tip about spraying the seal. Quick, practical and easy to deal with.
Kofi B.Homeowner, Downtown Bellingham
Sensor kept reversing the door halfway down. They found a loose wire and a misaligned photo eye, fixed both and reset the travel limits. Showed me how to test the safety reverse myself. Fair pricing and they showed up when they said they would.
Hannah W.Homeowner, Fairhaven
We cover Downtown Bellingham and Fairhaven, plus the surrounding streets and the routes in between.
Schematic only. Not to scale.
Type your ZIP code or town. If yours is not listed, call and ask.
These are the questions we get most on the phone. If yours is not here, call (508) 413-6765 and describe what the door is doing.
Describe what you are seeing and we will point you to the right next step.
(508) 413-6765You get a written estimate before we start, and the price on it is what you pay.
Ask any company three things: do they show you the failed part, do they carry the parts on the truck, and do they test the safety reverse after the repair. We do all three, and we will tell you when a repair is not worth it and a new door makes more sense.
Scheduled repairs run during normal business hours, and emergency Garage Door Repairs Bellingham open now calls get first priority the next morning. Call (508) 413-6765.
Ask whether they replace springs and cables in pairs, and whether the estimate is written. A company that answers those four questions plainly is the one to hire.
Yes. If a spring has snapped and the door is stuck open, or the door is off the track and hanging, call (508) 413-6765. We will walk you through securing it and get a technician out as fast as we can, often the same day. Never run the opener on a door with a broken spring or cable.
Call (508) 413-6765 and describe what the door is doing. We will tell you the likely cause, a price range, and whether it is safe to run tonight.
Call (508) 413-6765 or email info@lergaragedoorrepairs.com and tell us what the door is doing. Most calls in Bellingham and Fairhaven get a same-day visit when you reach us before noon.